Posted by John T on July 22, 2021 at 13:47:00 from (45.16.200.171):
In Reply to: Weak spark posted by Ted in NE-OH on July 22, 2021 at 11:23:13:
Ted you ask a good question ' Is there anything that kills coils?'
Sure, excess current or excess heat are a couple that can. If you have a 12 volt tractor and a CORRECT full true 12 volt rated coil (around 3 ohms) Id expect no more then 4 or so amps of coil current. If its much greater like 6 amps the coil can overheat and be damaged. That could be caused by an incorrect too low of resistance coil. A full true 12 volt rated coil would have around 3 ohms of LV Primary resistance thereby allowing about 4 amps of coil current HOWEVER if it was a 6 volt coil (around 1.5 ohms) and drew 8 amps it would overheat and be damaged. CHECK YOUR COIL RESISTANCE AND CURRENT WITH IGNITION ON AND POINTS CLOSED Id expect 3 to 4 amps if allllllllll is well ???????
If the coil is NOT the problem but the spark is weak, you could have burned pitted corroded mis gapped or carboned up points (Always check and suspect points first),,,,,,,,, A faulty condensor,,,,,,,,,,,,,A bad/resistive connection causing excess voltage drop (check coil voltage with ignition on and points closed, if its way low that can cause a weak spark),,,,,,,,,,,A faulty resistive voltage dropping ignition switch (again check coil voltage)
While sure coils can go bad, I suspect the points or condensor or a wiring or connection or switch problem FIRST. After that bad plug wires or a dist cap or rotor problem.
Run my Ignition Troubleshooting Procedure may help
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.