Posted by John Laz on June 25, 2021 at 22:21:30 from (75.105.61.39):
I recently decided to replace everything in the hydraulic system on my loader due to leaking cylinders, frayed hoses on the verge of blowing and a control valve assy that was falling apart.
I went ahead and sprung for all brand new components to hopefully make life easier.
So far, not the case.
Its all installed according to specs and diagrams Ive been able to find. The problem is that when I engage the lift, it only booms up about 3 inches. If I back off the lever and release some pressure, I can engage it again and boom up another 3 inches. I can raise the boom up all the way but only 3 at a time.
The other problem is that the bucket cylinder wont go in or out but the system loads up like its over pressure.
Im pretty confident that all components are in good shape and seals are good.
Ive never replaced a complete system before and was hoping for a plug-and-play program. Im at a bit of a loss as to what to try next. It seems so close to working. Any ideas are appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
