Posted by MSFARMALL on May 25, 2021 at 10:48:47 from (162.72.200.195):
I grew up around old people in a rural area where life was hard for them in their earlier years. Most everything was done by hand; manual labor, with the aid of the limited equipment that was available at the time. They cut all their wood used for heating and cooking by hand with a saw or axe so it was a very work oriented living. Most everything that was grown and harvested was also done by hand as the old horse or mule was the only powered equipment available. I am sure if you asked them if they worked hard, the answer would have been an emphatic yes. Approximately, thirty years ago, I bought land on which the timber had been cut and it was a terrible mess. Skidder ruts and brush piles everywhere but I finally got the land cleared and replanted, using tractors and chain saws, etc. I have told everyone I put a lot of work into clearing the brush piles, building roads and filling in ruts to get it where it is today. But, again, most of this work was done by tractors and other mechanical equipment. So, I am almost ashamed to use the word work to describe what I have done in comparison to what the old folks had to do just to stay alive. What do you folks think? Is it fair to actually call what we do today with all the automated equipment that we have available work?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
