Posted by Michael Soldan on May 18, 2021 at 06:03:35 from (148.170.140.200):
I often see trailer lights discussed and they can be a pain. I have a wire attached to my trailer frame, with plug and one on my truck frame with the opposite plug end . This is in addition to the 6 prong plug with the ground wires incorporated in it . Many believe that the trailer will ground itself back through the hitch but that's a myth. So I have a direct ground along with the wired ground wires and I never have a problem with trailer lights. I used to maintain a fleet of 20 trailers for a mechanical contractor and I can guarantee you that 90% of all light failure is due to a bad ground. I even ground the tail lights to the trailer frame with a short piece of wire , and self taping metal screws I also did electric trailer brakes, cause for failure there was a wider scope. Usually the magnets were burned and not functioning . The actuator arm was rusted and siezed and wouldn't appy the brake shoe . The adjusters were siezed and the shoes not making contact with the drum. In terms of time and money the boss and I discussed rebuilding brakes vs buying the complete assembly. A new brake assembly goes on with four bolts and splice of two wires and done. The labour savings are signifigant. I will say one thing about electric brakes , they can be working fine one day and the next day they aren't ! You can check by having someone put the brake on in the truck and you should hear them humming..SO...Ground ! Ground ! Ground ! and your lights will be good to go !
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
