Posted by tomNE on May 13, 2021 at 11:11:16 from (98.18.65.57):
In Reply to: ih cyclo planter ? posted by swindave on May 13, 2021 at 07:09:28:
some of paul's facts might be a little off but he hits alot of them. Case/ih 800, 900, 950 and 955 plus 5400 and 5500 soybeans special drills have industry leading opening systems. if you want picket row stand, buy a JD, if you don't no-till. if you no till put up a shop that your planter fits in, cause you'll be working on it, a lot! keeping the seed Vee clean on a JD in no till is a fulltime job. (varies on soil type but about 100acres per row unit, give or take) but it can be done. The bottom of an IH planter was/is industry leading. the new JD planters that no one can afford have the same offset discs and are GREAT planter but you need to buy a new tractor to pull them. Takes 2 hyd pumps in the tractor. in my area, maybe not paul's, even emergence has a much greater affect on yield. IH and now new JD have the same openers. I farm dryland in nebraska where mother nature controls my yields not picket row planters. No upgrades needed on a cyclo planters, to no till. Set the factory down pressure to max and go plant. 30 years since my soil has been tilled, my renter uses an older JD and it plants fine into the green rye. But he rebuilds his 16row every year. JD, knows they have a problem, now offers a complete row unit that bolts right onto your old planter tool bar complete, much easier to do and almost as cheap as rebuilding everything by hand. And yes, Gleaner wasn't close to first on rotary combines!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
