[quote="CVPost-tomstractorsandtoy"](quoted from post at 05:43:54 04/19/21) We finally got the 71 back together after fixing a bad shaker drive and replacing 4 bearings. Shelled about 800 bu so far and hope to finish the crib today. Goes slow working alone as I have to stop and empty the cobs out of the manure spreader twice for every load of corn. Here are a few pics of just shelling off a wagon. It is set at the corn crib now. Tom
<img src=/cvphotos/cvphoto85543.jpg>
<img src=/cvphotos/cvphoto85544.jpg>[/quot
In your other post I was going to ask you what brand of sheller you have but this one answered my question. I never did work behind a Deere sheller very often. The neighbor had a guy come with a truck mounted Deere but the rest MM. We hauled the cobs to the cattle yard to give the cattle a dry place to lay. That pile was hauled out and spread on the oat stubble in August. Dad had a Caswell loader on a Deere A to load the two spreaders. My sis drove the 630 Deere pulling a Deere L spreader if I remember right and I drove the 35 A pulling a Deere N spreader.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.