FUN SPARKY DISCUSSION YALL Ive enjoyed it. With all due respect, I'm still going to Polarize and tell others the way I was taught and used 50 years never a problem, but hey anyone can do as they like with their tractor, fine by me.
For discussion, I will add on the B circuit in order to pass current from the VR's BAT terminal to and through the internally grounded field coils you obviously need hot voltage, sooooooo if jumping BAT over to ARM on the Class B VR causes hot voltage to be present on the Class B FLD control relay input (has to eventually get there to supply and regulate field current to ground)
IFFFFFFFFF the VR's Field Current Control Relay contacts are closed ??????????? and IFFFFFFFFFFF that field current control relay input has hot voltage present via the ARM terminal
INDEED IT WILL PASS CURRENT THROUGH THE FIELD CURRENT CONTROL RELAY TO THE GENNYS FLD POST TO GROUND THEREFORE POLARIZING
Personally Id rather NOT have to pass polarizing current through the VR's field current control relay in order for current to flow through the fields to polarize BUT CHOOSE TO JUST JUMP VOLTAGE DIRECT TO THE GENNYS FLD TO AVOID IT HAVING TO PASS THROUGH THE FIELD CURRENT CONTROL RELAY CONTACTS........
Hey its ones own choice how to do it I SUPPORT ONES CHOICES FINE BY ME but Im sticking to polarizing a B Cicruit by direct jumping voltage to the FLD and NOT having it pass through relay contacts
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.