Jonas welcome to YT! I would suggest to drain the belly pump ..Lift-all.. pump before you pull it. That way if it tips on you once you have it out you wont have a big spill puddle. The pipe fittings that screw in the housing will have to be removed, one on the right and two on the left ..everything on a tractor is referred to as you would setting in the seat.. and the lever on the right will have to be removed. Be careful use a floor jack to lower it down it is heavy. You will also have to get the drive ..puck.. lined up so it can slide down, this is accessed through a removable plate underneath. It drives off the front of the lower transmission shaft. I can send you a link to a scanned copy of an early IH service manual for your tractor. Just view this in ..Classic View.. and my email is in the lower right. The manual does not give detailed step by step to do this task. It is written for someone with mechanical experience or maybe even assumes you were trained by IH to work on the tractors but there is a lot of need to know info in it. My tractor is a 48 M been in the circle of relatives since new. Here is a picture of it. I have a hood on it now and this was before I got the Horndraulic trip loader cylinders on and hooked up to the live hydraulic pump. By the way you are working on only ..gears.. the name pulley refers to an item that operates with a belt, like fan or water pump pulley.. I will also attach a link to the current companies parts site that own the International name sake as of now. It will hopefully open to the M transmission parts page. But you should be able to navigate back to all the parts sections for your tractor. Now granted they no longer carry a lot of parts for those tractors and in quite a few cases if they do they are priced high. However, I should also say that YT carries a lot of parts for your tractor, infact they probably have the gears you a looking to replace. I think I looked it up a while back because I need to do the same to mine because it pops out of 5th gear. Good luck!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
