Posted by RedMF40 on March 30, 2021 at 18:58:34 from (172.58.187.123):
I first learned of the Keystone museum when it was mentioned on this site. I knew I had to go, so yesterday with the nice driving weather I took off work and made the trip down south. It is in the Richmond, VA area--town of Colonial Heights to be exact.
I took a lot of photos. It's allowed. I'll post some now and again because dumping a bunch of them all at once is a bit overwhelming. There's a lot of stuff there.
The first series is a tractor that I probably spent more time on than any of the other exhibits. It was built from scratch by a man who not only fabricated the whole thing using an Indian motorcycle engine for power, but also built the AC welder that he used to build the tractor. Check out the level of fabrication, the big hydraulic cylinders he put on it. One thing's pretty certain: After he'd tightened the last nut, welded the last bracket--he's the only one who would have been able to operate it.
Also outside the museum was a neat exhibit I call the "Rust Carrier." Car carrier and cars as they found them, unrestored.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
