I have a number of Rigid products,, screw gun, 8 years old used a LOT still all like new,, 71/4 hand saw (this one is a a good as any high dollar one I have used) 9' plug in grinder,, not as smooth running as my Sioux but 1/4 the cost,, plenty of power and happy with it,, drill press, 7 years old used all the time works like new yet,, jaw horse type vice,, 12 years old works fine,, sits outside 99% of the time,, I bought a 4' cordless grinder,, works fine but eats juice up fast, I have two shop vacs,, both bought on the black friday sales,, both under 40 bucks 6hp rating,, one in the house other is used in one shop or the other, it has sucked out my drills for the past 12 years,, both still work like new,, never needed a warranty on any item yet,, to me they all have ran way past any other mfgs warranty would have had any way,, I have owned millwakee, dewalt and black and deck por series,, what i have now is far better balanced and holds power longer than any other brand I have bought,, all the others are long since trashed with less hours than what I run now,, for me I will buy this brand when I need more,, very happy with it so far,,
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
