Posted by bc on March 20, 2021 at 06:30:04 from (24.255.129.137):
Got an addon to the barn that leaked like a sieve this week with the rain we got. It has always had a few drips but this time I had 10 buckets around my work bench area and another 6 spread around. It is running down mainly 2 seams of corrugated tin and then dripping in at each 2x4 runner across the roof. Last year I went up with some clear silicone roofing caulk and caulked the seams and some of the screws.
The part that is added on is 32' wide with a 24' long roofing run. There is a 6' rise over the the 24' so is a 4:1 slope. Has two skylight panels in it. The screws are screwed into the high portions of the corrugations. Mostly no rust except a little below the 2 skylight panels.
Wondering what is the best coating to put on it but don't want to coat the whole barn or put any black stuff on it. The barn roof is fairly steep and in good condition so don't want to get into too much of a color mismatch. I've used the mobile home stuff before on flat roofs. I don't have anything that will spray thick stuff and if I brush the stuff on then I wonder if it will tend to fill in the corrugations. I'd like to buy an airless sprayer some day, just need a good reason to get one.
What do you guys recommend? None of that stuff is very cheap. Got more rain on the way and will probably hang a tarp underneath and direct the drips away from the bench.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
