Posted by bc on March 12, 2021 at 07:24:34 from (24.255.129.137):
Hello guys. Been putting my 2606 back together and wonder what the correct torque values should be for 1/4" and on up to 5/8"? The table I pulled up on my phone and have been using is all over the place and different numbers for galvanized, plain, galv + wax. Been using most of the old bolts which I think are grade 5 but have replaced some with grade 2. Typically use anti-seize except the blue locktite on the 1/4" fan bolts and red on the flywheel. Been going with the higher values. The IH book has 90 for head, 60 for flywheel, and 25 for manifold screws but these are special applications. Think I was using 150 ft. lbs for the 5/8" bolts. I see now that I have to pull 2 head bolts to add the tank bracket and then tighten them back down. Thanks. Just trying to be consistent. Been replacing most of the lock washers as a lot of them are flatter than a pancake after 50+ years. Most are coarse thread but I see that the 1/4" fan bolts are fine thread and I used 12# on those.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.