Posted by gbs on March 10, 2021 at 20:08:47 from (71.217.169.122):
we have tractor with a ccls pump that once you move any of the controls signaling the pump thru the load sensing compensator valve to meet the demand for that circuit up to 2800 psi it will not return to stand by pressure of 350-400 psi, after a barrage of system test the pump was rebuilt even though there was almost no signs of wear, put on a test stand and checked during which time the compensator valve was replaced as it was doing the same thing while on the stand. The replacement was a used one that worked correctly until it got put back on the tractor, so a new OEM one was installed it worked about 6 times correctly but the max pressure had to be lowered, after that adjustment then it started locking in demand not returning to stand by. All three of these valves have had the signal line opened via a line and screw valve connected a tee fitting at the X port of the compensator valve when the pump was locked on demand to insure there wasn't pressure present, even though there was 0 pressure at the X port of the compensator valve the pump stayed on demand until the engine was shut off, part of the time it would still be on demand after restarting the engine. Also if the max pressure valve is adjusted the pump pressure will adjust accordingly. Is it possible to have 3 bad control valves in a row or have I missed something?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.