Posted by bcny on March 04, 2021 at 12:06:12 from (47.18.252.123):
I have a general question about the tire size matching front to back, to maintain the front to rear axle ratios, on 4wd tractors. Question is do the manufactures make the tractor with a single set of gears, or do they change them to accommodate R1 vs R4's vs turf? I highly doubt that they swap ring and pinion gears in the tractors just for the different tire options. But what do I know, plus I am too lazy to look through parts books and see if different sets are called out for the tire options. It could also be a set of gears in the "transfer case" or equivalent. What is the industry practice?
FWY-my specific interest is a Kubota 4wd HST MX4700 with turf tires/wheels. Wanting to go to R1 ag tires/wheels. This is a tractor I want to buy. I should have noted the current tire and wheels sizes but didn't, just that "it has turfs". Inch sizes or metric, I don't know. 2013 model year. Thank you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.