Glad to see you are getting the repair underway. Actually if all is right in your hydraulic system there will be little to no air in the hydraulic system. So the statement about the cylinder ending up on the other side of the barn is only adding a colorful ..what if.. to your story. When you operated the lever to push the piston out of the cylinder once the seal between the cylinder tube and it were broken the piston and ram would simply fall away under gravity. Liquid does not compress that is why pressure vessels and piping are hydro tested, so if there is a weak area that fails the release energy is very minimal at the point of failure. For a hydro test the internal volume is filled with a fluid test media which is quite often water, bleeding out all air or at least every bit within reason. Then applying pressure to a predetermined test pressure. I would guess quite a few have seen pictures of an air tank that has failed and quite often it shows a large ripped out area. That is due to the stored energy the compressed air contains. A failed area during a hydro test will be a small non deformed hole, crack or gap. Once the pressure that is slightly deforming or stretching the item under test is released nothing else happen except the test media slowly drips or trickles out of the failure point. Understanding there may be air in the system the precautionary measures of the constraint of the strap was a good idea. I am also in no way singleing out George or his methods just additional information from my experience.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.