I think it might take 4 hours to clear the lot with compact tractor loader/back blade. Mention of skid steer. Would a skid steer with snow bucket be better than tractor/loader bucket/back blade? Are chains required on a 4wd tractor (using loader bucket and back blade)? How about the skid steer. In the summer, if they drove the skid steer on the grass, I suppose they would tear up the grass?
They said not so enthused about snow plowing pickup truck, I guess because they think they can't remove the snow like they would want. Plus DMV registration and insurance. However, if I were driving the snow plow truck I think I could fix most of the problems, but it would take more time. Pull snow away, then push it to a corner. However, I am not volunteering for 3 in the morning blizzard time snow plowing. I already use my tractor to mow their 2 acre field- in the summer, at time of my choosing.
I can see the merit in the "cut a deal with a church member" strategy, let him attach the churches snow plow to his truck, handle the church, then go out and use it to make some money.
While the contract service does a quick job, it still leaves a lot of car stalls at least partially blocked with snow. This is why I think they want to pick-up the snow and dump it on the grass areas. Plus the average 5000 dollar per year expense. Long Island NY, 5 to 6 snows per year. In the last 10 years the deepest single snow was 27 inches. The church looked like it had a snow wall built around it after plowing.
All the other questions about insurance and liability, I don't know. Lots of ways to go, I will discuss with them, but they asked me about tractor or Bobcat idea.
The more I think about it, they should just keep paying contractor. Thanks
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
