Posted by Geo-TH,In on February 24, 2021 at 05:01:00 from (184.19.63.28):
My handiest, most useful tractor is also my most problematic. I had to use high a tech leak detector, cardboard. I'm trying to train the terramite not to pee on the pole barn floor. Use cardboard to find leaks and keep floor clean. I had two remove 2 cylinders to see the hydraulic hose that rubbed against the cylinder and started leaking.
So I'm off to a place in town that costom makes hydraulic hoses to exact length. They also sell a sleeve to put over hose to prevent this from happening again.
This tractor is very prone to peeing on the floor. It has 9 hydraulic cylinders. 18 hoses to cylinders plus more. If this tractor isn't leaking oil today just wait until tomorrow.
This terramite is 17 years old. Other one is 20. It's the one I rebuilt the Dana rear end. It developed a peeing problem. I thought the worst, rear end leaking.. instead It was hydraulic hoses above the axle started leaking from old age. Sounds like an old man's problem, hose leaking.
If I'm not rebuilding cylinders I'm replacing hoses.
So what's your handiest tractor? What's your most problematic? My terramite answers both questions. Will my Kubota replace them? No, even though Kubota's hydraulics is superior. If Kubota were to clone the terramite I would by the clone in a heartbeat
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
