Posted by fixerupper on February 18, 2021 at 13:31:07 from (100.42.82.64):
In Reply to: Will it start? posted by fixerupper on February 18, 2021 at 09:49:29:
The Case gas tank is the reservoir for the hydraulic press. It is much too big for the requirements of the press alone. When I burned wood for heat I would bring in a wagon load of wood and use the pump on the press to raise the wagon to get the firewood to slide to the back. I needed a bigger reservoir to satisfy the big cylinder in the wagon hoist. This gas tank was what I had available to make a reservoir out of.
The Rambler has a 196 cube inline six and it has three on the tree with the old style overrunning overdrive. When the air conditioning worked the cold air came out of the top of the dash through two doors that can be flipped up. It was very cold air, did a good job. That little 6 cylinder didn't have much power to begin with and when the air conditioning was running it had even less. I will have to look at the carb again but I suspect the air conditioning kicked out when the throttle was wide open for passing another car (hah!). Maybe I am thinking of another vehicle from back in those days. I do plan to hang a spare gas tank because a new inline filter will probably plug right away.
Top end is 80 MPH so it is no speed demon and certainly not a mountain climber!!
I have watched that Vise Grip garage guy. It's fun to watch him. I am certainly not going to get this car in good enough shape for someone across the state to drive it home. The right front wheel just slides along so there is more than just power train to work on. A rear wheel was sliding making a black mark on the shop floor when I pushed it in but it might be in gear. The doors were frozen shut so I couldn't check the shifter and the loader tractor I used to push it didn't know it was pushing anything anyway.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
