Posted by used red mn on February 15, 2021 at 23:05:25 from (75.73.112.20):
In Reply to: More feed grinding... posted by coonie minnie on February 15, 2021 at 17:33:46:
Back in the day on the farm in KS, if I remember right we had a 357, I know it had the larger mill which I think was a 21 in. I think the small was 16 in. It also had the larger mixer like that one looks to have. The tank cone is nearly 4 foot in diameter at the bottom and inside is another mix cone that turned with the vertical auger. When that tank was nearly full it took a fair bit of power to turn it. We used the Farmall M I now have on it most all the time. When that tank was near full there wasnt much left to power the hammer mill. The old M spent quite a bit of the time on that thing with the governor holding the carb throttle plate wide open. Quite often that was my after school job to grind a batch of hog feed. We farrowed in a 17 sow house, with 3 sets of sows a year. We would fatten out all the pigs produced, which counts up to quite a few with 10 - 15 per litter. Later they bought one with a smaller mixer, that one a Farmall 300 could run in a pinch.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
