Posted by Ken Macfarlane on February 05, 2021 at 06:10:09 from (142.166.168.2):
I've been working on an 600 gallon old milk tank, getting ready to pressure test the dimple plate heat exchanger. Is there a way to tell from the connections how many passes or sections to the heat exchanger/evaporator there is?
It looks to have a single 1/2" liquid line in the bottom and a pair of 3/4" vapour lines, one one each side near the top making me think its one big section or there would be a pair of liquid lines. I know on some old leaky tanks you can pinch off the bad side of evaporator and keep going on the other side.
Second question, does anyone know what the connection to the dimple plate looks like for these lines without cutting open the skin? I've watched a ton of milk tank repair videos on YouTube but they never show the liquid or vapour line connections. Also never shows up in literature on the tanks.
Looking to enlarge the 1/2" connection to put water through the direct heat exchanger instead of freon.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.