I say go ahead and build. Interest rates are going to stay low so housing demand will stay high. Lumber industry is going to face increased taxes causing prices to go up. Then there will be changes in EPA and other regs that will limit the cutting of forests. Trend is for composite anyway. Most commercial buildings are using steel studs and I'm seriously considering those for a house and some already do that. I'm looking at stuff that doesn't rot or need paint even though a little higher going in. With all the rain you get down there I'd think that is something to consider. I remember basic training and infantry AIT at Fort Polk and it seemed like we were always humping around in the rain forests there and eating wet grub. Been wanting to stop in and see the place during our trips to Florida and then heard they tore out all the old WWII barracks that we stayed in. Had to keep the windows open in the winter for ventilation to avoid URI. 40 degrees at 100% humidity just freezes a person all the way to the bone.
When all the tree huggers, bird huggers, lizard huggers, skunk huggers, and the mice huggers jump in to preserve forest land again the price is bound to go up. We need some more swamp loggers like the ones you have down there. Liked to watch the one who raced around wrecking his boats wearing shorts and shinnying up trees. Remember the time he pulled his pistol out, started shooting, stuck in his pants, and immediately pulled it out saying darn that was hot!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
