We had a Mongomery Wards gravity fed hammer mill in the grainery. The oats were there, but we loaded a flare box with ear corn from the corn crib and hauled it to the grainery to grind. It did not handle wetter ear corn in the fall; easy to plug. Dad used a 1929 JD D to grind usually with a vee chunk of wood to help hold the belt tight. The D really barked when he was finished grinding, so I would have to be coaxed to remove the block when he backed up to ease the tension on the block so I could remove it. When Dad built our new corncrib, he mounted a Montgomery Wards grain buster hammer mill with a travelling feed table on 2-7' channel irons so we could put it in the corn crib and shovel ear corn directly into it. We could move it up the alley of the corn crib because he buried 2 pipes in the concrete so we could stake it down several places. We used a 1946 A or a 1951 G to grind. When using the A, we had to feed it a little slower than the G which the mill would eat the corn as fast as we could shovel. Dad died in September, 1970 when I was almost 16. I used the mill another 7 years until the main shaft on the hammer mill broke off (it had a steel pulley on it that I could not keep tight and running smooth). That was a very sad day for me because it worked so well. I used a mix mill for a couple years (not nearly as handy!). Then I put up a use Harv for hi moisture corn. Except for Dad dying, I have a lot of good memories. I wish I could download pictures from my head to show you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
