We don’t know exactly what to do. Would like to have breaks and preferably parking/emergency too. My question at the start of the post was, in a nut shell, was what axel might we have? We don’t appear to have the correct wheels but the fronts and rears are all the same bolt pattern, 4.5” 5 log. Still has the original Green diamond engine in it, which as it stands will run (though who knows how long will last; I figure though it’s not cracked so it could be rebuilt if needed), and what we believe to be a good original trans. Willing to try swapping in a ‘85 S15 or a ‘94 chevy S10 blazer as we’ve acquired those thinking of the truck, though the Blazer has larger 4.75” 5 lug bolt spacing and probably will need spacers to get tires out wide enough, which should negate the spacing issue. And if we could find an original ‘36 IHC C1 rear end with in 30 miles of 85355 we’d probably do that, though I don’t think that’s possible as to our knowledge our axel is long gone/lost. Lots of options though if we can keep welding to min that’s the best-Dads a better mechanic than welder. Even have s15 doner could do the full hot rod route, but that will take a lot of welding. Probably never drive or show it much, but would like to have it drivable and as it sits it’s not with no breaks, need springs and wheel cylinders for the mystery. Bout as clear as mud, which is what the S15 is now sitting in curtesy of flood irrigation.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
