Posted by DeltaSteve on December 30, 2020 at 08:27:49 from (67.41.195.225):
There are a couple of those AC WC graders here. One is owned be the dirt race track.There is a Huber tractor with a blade and an air compressor that sets out on the hyway.A local (private)airport has an M with a 'long nose' and a grader blade. It looks like a tractor with an 'add on'. It is a factory built outfit.A good friend has a small Heil grader built from an W4 IH.The engine has been set on top of the rearend,belt driveing the transmission.Looks like a common ordinary grader,with engine in the back. Has the original factory built cab. Single drive wheels,7.50x20 truck tires on front. All hand controlled.Says his father bought it new in about 1940 in Denver. Took it up to Evergreen where it plowed snow,built roads,worked the familys construction business. He has been 'restoreing' it for about 15 years. But still uses it from time to time as he works at the 'restoration'.Did any other companys make graders from farm tractors?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.