Posted by JustahobbyMn on December 27, 2020 at 07:01:12 from (172.76.63.207):
Hi guys. Ive been watching this forum for probably a good 10+ years but am new as far as posting goes. This may be long, but I wanted to give a full description before asking for options.
I have a 51 Super C that I use probably 50-100 hrs a year. Over the last 15 years I have rebuilt or fixed nearly everything except the rear tires and the rear end, with several modifications along the way to make it more user friendly for me. I found a loader back in 2008 or 2009, and converted it so that it is all hydraulic. There were issues with the touch control box/manifold that sits under the gas tank so I welded up a custom steel tank and rebuilt the pump. Now I have power up and down on the loader, which is really nice being able to lift the front end off the ground. My question is how can I get a three point on this tractor? All of the kits I see for a C/SC are controlled by the manifold that I removed. Would an aftermarket unit from an H or an M fit onto the rear axle if I plumbed it into my hydraulics? Or is there a better way?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
