Hp to pull the spreader is important, and the overall weigh to be able to handle the weight of the loaded spreader behind it. Not much of a concern if your land is flat, but not something to ignore if your farm is hilly. A loaded manure spreader can push a tractor around like a toy when going down a hill. Could push the tractor through the fence, or cause the tractor/spreader combination to jackknife, possibly overturning the tractor. The other main consideration would be hydraulic flow rate. As you state your spreader has a hydraulic apron, check the hydraulic flow capacity required to operate your manure spreader. While I am not familiar with the model spreader you have mentioned, I will show a picture of my Case 930 with the Hagendorn , which has a hydraulic powered push gate, not an apron. The 930 Case is right about 85hp with a 12 gal hydraulic pump, and weighs near 10,000 lb. I wouldn’t want any less tractor on this spreader. The engine has the power, but the tractor is nearing the weight limit, and you know that spreader is back there.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
