Posted by JRG1 on December 19, 2020 at 16:08:28 from (220.235.106.26):
Hi, I am new here and not sure if this is the right place to post tractor problems so apoliges if it is not. I have a 1954 Fordson major diesel and have a fuel problem in that while working in a darkened shed I mistakenly topped up the fuel tank with petrol. The tractor had run perfectly ok up to this point and continued to do so for 20 minutes or so until the fuel mix reached the cylinders when the motor stalled. I realised my mistake and emptied the fuel tank (fuel cock fully open),both cannisters and the injector pump. Then refilled the system with clean diesel. The motor started ok but revved uncontrollably and backfired occasionally. The only way I could find to control the revs was to starve the motor using the "shut off" leaver at the rear of the Simms injector pump. I ran the motor for half an hour or so controlling the revs in this manner in an effort to remove all traces of petrol. However it still revs uncontrollably and the throttle leaver has littel or no effect even when raised to the vertical position which used to stall the motor. I don't like to disassemble the injector fuel pump for fear of upsetting the settings. I have checked the butterfly valve on the intake from the air cleaner and this seems to be closing ok. Can anyone please tell me my best course of action? Cheers, JRG1.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.