I'm guessing your "Ford" manual is actually an I&T manual. My Ford factory shop manual (covers 600 series up through four cylinder 4000) has the same adjustment procedure that Royse showed, except it says to start "1-1-1/4" turns out rather than than 1-1/8. (I assume they meant to say "1 to 1-1/4 turns".)
Pulling three plug wires to set the main jet seems pretty goofy, but is it really all that preposterous? I don't think so. First, the only right way to adjust the main jet would be under dynamometer load. But not many farmers own a dyno. So you want to simulate heavy load conditions: Low manifold vacuum (aka high manifold air pressure), high carburetor airflow, and high engine torque. If you pull three plug wires and open the throttle all the way, you'll have low manifold vacuum and reasonably high airflow through the carb. Even though the three dead cylinders aren't putting out any power, they're still pumping air. The engine isn't putting out any torque, but the dead cylinders do present some load to the single live cylinder. I think it sounds like a reasonable way to set the main jet without a dyno or similar PTO load.
As for setting the main jet to eliminate "stumble" on acceleration, unless a carburetor has an accelerator pump or is a constant velocity carb, there's always going to be a slight stumble when you suddenly open the throttle. If you try to eliminate it, you'll probably end up with a rich mixture.
On the other hand, if you try to adjust the main jet at high speed but no load, the idle circuit will probably still be in play, enrichening the mixture. You're likely to end up with a too-lean setting when the engine is under load.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
