Posted by coonie minnie on November 19, 2020 at 18:23:02 from (65.31.173.114):
I thought I'd send a few pictures of where my family has been with tillage, and why we've abandoned the plow for no-till, and found success.
1970... my dad in the 5020 pulling 8x16's. Anyhydrous ammonia going down to feed the years corn crop.
Planting 1970 style. Still have the 4020, drove it today.
Planting this spring... no plow, no disk- one pass with the planter into alfalfa sod. John Deere 4455 on a 7200 6 row planter. Despite a smaller planter and much more acreage, it's easier to get done in a timely fashion when you are only making one pass.
A healthy crop. Not the best we've grown, but a decent crop of silage corn, no-till planted into alfalfa. Only 10 lbs of commercial N fertilizer applied as starter, the rest came from the previous crop of alfalfa and an application of manure the year before.
My idea of healthy soil. Note all the pores- no-till doesn't mean no tillage, but instead no tillage by tractors. All those little lumps are earthworm mindens. They've eaten all the old crop residue, and incorporated any manure spread. They've done the work for us, like nature intended. The soil is firm, but very porous, with much more water infiltration ability than with tillage.
The 1970's stuff was fun, but it took a lot of capital, time, fuel, and wear parts. Today we can grow twice the crop with less fertilizer, less fuel, and less time. Yes, we use herbicides, but we did back in 1970, too.
I'm sure there are a few here that will say "that doesn't work here" etc. It does work here, and allows us to farm full time with no outside income. I'm proud of what we do, so thought I'd share.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
