Thanks. Brings back memories. 25 years ago I thought I was going to get into the wheat crop business. Bought an overly used JD 95 and did primarily hydraulic cylinders restoration. After completing that, I felt that there was not a hydraulic cylinder that I couldn't rebuild as it had seemingly every type of "how to get it apart" there was. The movers and shakers were good enough, the engine responded to some cleanup but otherwise was ok, not pristine but ok, belts and tires ok. Got it in working order and was ready to go.
Got my first field to cut....whoopee....I have arrived......yeah right. Things were going pretty good and I unloaded the hopper several times. Desided to leave the chute out as it had a chain binder and chain (PO rigging) holding it in the dump position and was a pain to move back and forth. Come upon a larger than what you find in your yard, utility pole and execute the 24' header neatly around the pole complimenting my self on getting it right my first time with that experience.
Next thing you know, a couple of seconds later..........WHAM!!!!!!!!! Daaaaaa! The unloading chute that used to be attached to the combine was no longer attached. Son-in-law came with me pulling the header on a trailer so he was available. Finished the field by him holding a piece of 2'x16' (give or take) corrugated sheet in a U shape so I could unload into the customer's barn.
Epitaph: This field was adjacent to a main road in the area. Local came by as I finished working and stopped. In short, he bought the combine (for a song....good riddance) in the field as it sat. He repaired it and used it for quite a few years before he bought a 9000 series.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
