I make 4x5 dry bales; i have no problem there. I made some third cutting bales that had to be wrapped. Bales were around the 1200#+ area, and with one bale, I was dancing on the front wheels. I have a tire scraper that is a fair bit heavier (started using on a L325) than recommended by the scraper mfgr, and eventually the top angle on the scraper got humped up in the center. it put a lot of strain on the top corners of the SS mount and cracked it b/c of the single dump cylinder. Mostly my fault for wanting a scraper that went a little over half the width of the alleys. Probably not something that would affect you. As to finding attachments, there are some out there but not very plentiful. Consignment auctions are the best chances. I just had my local welding shop build a new bucket for me, using a mostly worn out bucket as a pattern. Cost $450, reasonable, compared to aftermarket buckets. Next up is a mounting plate for a bale spear. I have been using forks for the bales. I started with L325 skid steers, and kept after the same mounting system when I got the bigger ones. No aux hydraulics on either. Where are you located?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
