Posted by Bruce(OR) on November 12, 2020 at 04:19:14 from (65.102.27.56):
In Reply to: Chevy engine experts? posted by svcummins on November 11, 2020 at 19:13:07:
20" is a good number. Is that ported vacuum, manifold vacuum or venturi vacuum? Not moving tells me your gauge is sticking. '72 350 should be running about 8 degrees timing. Firing order 1-8-4-3-6-5-7-2 Point gap around .018 giving you the 30 degree dwell angle. Set the dwell first, then set timing. Place an index mark at the base of the dist base. If the mark does not move, neither does the dist in the future. Reset your dwell back to 30 degrees and the timing will fall back in.
As long as your playing, Hold the timing light on the timing marks. Does it bounce around at idle? Worn timing chain. Rev engine about 1800 Do the timing marks bounce? Worn dist shaft bushings.
Brucewellis@aol.com
Looking for higher mileage? GM Lean drop carb adj works well.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.