Posted by buickanddeere on November 10, 2020 at 19:32:57 from (216.183.134.207):
In Reply to: New starter posted by svcummins on November 09, 2020 at 22:35:27:
[quote:a9719dbaf5="rusty6"](quoted from post at 21:46:30 11/10/20) [quote:a9719dbaf5="buickanddeere"](quoted from post at 17:33:00 11/10/20) [quote="CVPost-rusty6
Here is what that 2140 needs to wail it over on a cold day . A 4Kw gear reduction starter. Why settle for a scrawny 3Kw starter ?
,
I forget ,Did you get around to installing a destroker on that front pump ?
][/quote:a9719dbaf5]
That does not look like my 2140 starter. Numbers don't match up to any of my searches. I found one listed at A&I matching the original JD number. Original style Bosch starter at $349 before shipping. Have not checked with JD yet.
I'll concentrate on the starter before doing anything about a destroker. I know the starter is bad.[/quote:a9719dbaf5]
Why are you stuck on a factory appearing 3Kw starter instead of 4Kw starter that will improve cold starts ?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.