if it is vinyl lettering, it can be removed, but you are in for some work, and the plastic behind it will have a ghost letter from the weathering of the plastic..
I used to work for a print shop, and we did a lot of that kind of stuff.
a single edge razor to get under the edge of the vinyl, is pretty much an essential took, sometimes you get lucky and most of it will pull off reasonably well.. other times it will be a fight.. depends on the color and grade of vinyl used.
a product like goof off or goo gone will help get rid of any remaining glue residue
after that, I would recommend a light sanding with fine sandpaper - 400 grit or higher.. to help with the ghosting. a good plastic polish, like Plast-X can also work wonders here.
To applying new letters.. clean thoroughly!
lay out the lettering with backing still on.. get it positioned exactly where you want it and tape it down.
make sure you tape the middle down well top & bottom.. untape one end.. leave the middle taped! peel the backer off and remove it just from that section.. hold the end up & use something rigid, but not hard (old window squeegee works well), to help lay down the lettering nice & flat, no bubbles, working from middle outward..
once one end is down, you can remove all the tape holding the rest in place, and repeat the process going the other way..
once the lettering is applied, but before removing the masking, burnish every letter down really well - old credit or gift card works perfect for this step. hit every part of every letter.
After burnishing, remove the masking, step back and admire you work.
if you find bubbles.. poke the center and use a heatgun on a lower setting (hair dryer would also work) the heat draws the air out of the bubble. but be careful.. too much heat will damage the vinyl.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
