Posted by john achmann on October 26, 2020 at 09:24:28 from (174.219.135.194):
So I’ve been a diesel mechanic for the last 25 years. Been also doing side work at my shop at home for about as long. I’m not afraid to work on anything. I’ve noticed the last couple years that the work has picked up. This year has been extremely busy to the point that I have turned some work away because I don’t have the time. I’m to the point I need to crap or get off the pot on going out on my own. Just concerned about the unknown. There is a few other shops in the area but one the guys that own it are older and in a few years will retire and the other one has trouble going to get equipment after asked to work on it. I have a cousin that has a transmission shop that told me if I like what I’m doing where I’m at don’t quit. That’s problem number one. I like what I do most days but there’s days that I just can’t get into working with what’s going on. The second problem is the lack of communication at work. It’s horrible! Had an issue again this morning! I think I’ll make it go but to convince my wife that I can is troublesome right now! I’d say with what I have sitting in my yard and what I have to go get I’m all of a month and a half behind. Had two guys send a message this morning for repairs. Didn’t answer yet cause I don’t want to let them down and trying to figure out how to fit them in. I’m guessing there’s some of you that made this leap. What was the deciding factor to go on your own? My father always said I’ll never be happy if I’m working for someone else. I believe he is very correct on that as he worked for himself for twenty plus years. Yea there was days he said was bad but never came close to all the good days. Any bit of advice, concerns or comments will be appreciated! Thanks for looking!!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
