Hello Mr. Gun welcome to YT. Don’t rule out the fact that something may have failed in the cylinder you had rebuilt. In general the hydraulic supply to the bucket curl function T’s off to each cylinder from one pair of lines coming up the loader arm from the valve. I don’t know if I can describe this properly but can you raise the loader to a point where the loader bucket cylinders are almost level? Then support the bucket some way so you have at least A quarter of the cylinder extension stoke remaining. Disconnect the hose that is closest to the end the ram comes out of. Make sure the cylinder is full of oil l, use a jug and a funnel if needed. Now use a plug to plug that cylinder port. Direct the loose hose into a catch pan or bucket. No pressurized oil will come out of the hose Now start the tractor and lift the loader arms to get the bucket weight against the plugged cylinder to see If the cylinder will hold position. If it is good do the same with the other one. If they both hold it is in the valve. Just to add I don’t know how knowledgeable you are in the operation of hydraulics but when you center a valve lever it is just trapping oil so it can’t flow. You are just using the plug and the oil trapped in the cylinder to tell if the cylinder seal is holding. If you can’t wrap your head around all this my request may be a little confusing.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.