Posted by jon f mn on September 13, 2020 at 11:05:31 from (174.219.4.208):
Baled some hay Friday after work, should be the last of the year. Good thing too because the pto went out on the 830 on the last bale. Got it baled but it quit before I got it tied, so one bale went direct to the steers. Got one other bale without tying because I grabbed the wrong hydraulic lever and opened the door instead of tying. Otherwise it went ok.
Had the annual family get together at the farm this weekend. All the brothers and sisters get together every year for a camping trip and gathering. I don't go most years because I don't camp. So this year it was decided that everyone would camp at my farm. They came Friday and left today. All the brothers and sisters except my oldest brother Chuck.
Top row left to right is Don, Dave, Mary and Bruce. Bottom row is Rita, Ken and me. Had a lot of food.
We told a lot of stories and laughed a whole lot.
A few of the kids and grandkids came too. Abe has a particularly big weekend with all the attention. Here he is sleeping off the sugar high because the pumpkin bars got left on the table over night and he got up there and ate one whole pan and licked the frosting off the other. Lol.
He was run pretty ragged by the kids who loved him. He's a real smart dog and going to be easy to train. He minds me very well.
Got everyone packed up and out by noon today, except my brother Jeff who left his jacket with his phone in the pocket. He was an hour away by the time we figured that out, so I met him half way to give him that. Think I'll take a nap now.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
