Posted by Destroked 450 on September 07, 2020 at 16:13:01 from (66.38.93.182):
Purchased this 2008 Montana/Farmtrac 555 a couple years ago disassembled with a bad engine.
Bought it on a online auction and yes I got it cheap, less than $1500 with the loader, but being disassembled and online we didn't know what all was missing or how bad it was.
Turned out the engine was junk, grill shell was badly damaged, grill was missing along with most of the bolts it took to assemble it.
It had good tires, a quick attach loader with quick attach bucket and joystick control that will fit my 4000 Ford, so I figured there was my money back if nothing else.
I had a 3930 engine in the shop that I did a ring and bearing refresh on, added a 3000 dual clutch flywheel with new clutch assembly and bolted it to the 8 spd transmission. The Farmtrac's front axle with hydrostatic steering was also a direct fit.
I used a late 3600/3610 geared hydraulic pump and suction pipe along with a power steering pump and lines for a 2810 to replace the Long style tandem pump arrangement that came on the tractor, I'm thinking Ford parts would be easier to find and replace in the future, a little bending was required to fit the Ford lines to the tractors orbital steering motor.
I modified a cheap aftermarket 3000 wiring harness to work with the instrument cluster and extra lights, also converted it to Delco 10SI charging system and added a 3930 grill with lights
Didn't want to waist time and money on paint for a junker mutt, but I think it'll make a nice little hay mover for the less than $3000 investment
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
