i apprenticed right out of school for four years for auto motive mechanic,from 75-79, and have a red seal licence which means i can do the job anyplace in the world. and have worked in a GM Garage. i sure hate bragging about myself but thats the way it is ,... you need a ticket to work on customers vehicles. same as any other trade. i also was re-ringing engines when i was 15 and 16 years old. at about 12 years old i was tearing those old iron horse engines apart to see what makes them tick and get them running. and the same with those ihc LB engines. now are you bragging about yourself that you have no trade? i can weld also but i cant go welding, i can do plumbing, but i can be a plumber. i can do electrical wiring, but i cant be an electrician. i also can change and balance tires or i used to then. did lots of front end work and wheel alignments. did engines , transmission and diff overhauls on them old 427 chevy gravel trucks with the 5 and 4 trans. install those target master long block 350 engines in 1/2 and 3/4 ton trucks. start at 8:00 and it was driven out of shop at the end of the day. i used to grind valves also in the GM garage. and sometimes i have to fix a broken heart . enough bragging. but there is more.. after that i worked on oil rigs drilling for 7 years. then supervised top drive department on rigs for lots of years. then after that been working in there shop as mechanic tearing down those drives and getting them recertified and put together for another 1000 days of drilling. now i am off work due to this covid stuff. there now more bragging about my life, not that i like to.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
