Posted by Texasmark1 on August 04, 2020 at 04:27:54 from (172.243.92.145):
As mentioned earlier, parts guy at the local Branson dealership took the initiative to find a part number for an expansion valve when the parts list only showed the evaporator assy. $43 TTL. Put it all back together with the new hose from the compressor to the condenser that I initially thought/maybe was leaking and pulled the vacuum. Couldn't get a hard vacuum and in short, the O rings in my 134a test equipment (fairly new) adapters needed changing.
Reason I am posting this is this surprise surprise (Gomer Pyle). Here you are scratching your head, trying to find the leak in your system, when your instrumentation that's telling you that you have a leak is the thing leaking. Other thing is that I found that finger tight isn't good enough to keep the hose connectors tight when you are doing a lot of moving around of the gauge set....pliers needed. HF has a kit of the HXXX type green washers for about 8 bucks and had a size to fit all my connections, including the O rings in my test equipment (gauge set) connectors.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.