Posted by bc on July 27, 2020 at 08:59:12 from (24.255.129.137):
Hi guys. Been working on my 50 year old well. Tried Jim's air bubbler system and got spurts of water. Found a 30 year old monkey wards convertible jet pump on the junk pile that ran. Hooked it up with garden hose and no luck. Took the pump apart and the impeller was gone.
Bought a 2 horse, 14 stage, 35 gpm, 230 volt submersible and ran it in with a 100 foot of 1.25 inch PE pipe using .75 inch PE pipe for conduit. Right now I have it sitting at 120 feet with 2 garden hoses attached to the 1.25 inch pipe since the supply house has the 1.25 pipe on back order till later this week.
Well data is 169 feet deep with water originally at 20 feet with 8 inch steel casing that has rust breaking off the inside. Been pumping on it for a few days at 120 feet. After pipe comes in I will go on down to 150 or 160 feet. Volume for 8 inch ID casing is 2.611 gallons per foot.
Saturday I ran it till dry. Yesterday I ran the pump after a 24 hour wait and it pumped for 8 minutes 6 seconds before going dry. A 5 gallon bucket test a few times shows it fills in 20 seconds so it is pumping about 15 gpm and recharged 121 gallons in 24 hours. I hope it does better when I can run it on down towards bottom.
Question is how do I hook it up for garden watering use and have it automatically shut down if it runs dry as I don't want to burn the pump up? First thought I needed a pressure tank but now think I can use a pressure switch just using pipe pressure. I have an old 20/40 pressure switch and I need to hook up a gauge on the hose to see what pressure is coming out although it shoots out a solid stream about 10 feet from end of hose. I assume the increased head pressure when I drop it on down will cut back on the flow rate and pressure. If the well won't sustain 15 gpm then I need to close it down some. Still have to pump it a long time before I can test it as a bucket of water is cloudy and it has an strong iron taste. Thanks for the help.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
