Roger would the later operators manual give and more info than the early one? My book is for below sn 115020. There does not appear to be a service manual for them that I could find with a Google search. It might be awhile before I get much more info as we are having other problems. A few years ago the track in my bale case broke where the slot for the plunger safety stop is. I took it to an Amish shop and told him to replace the track and sharpen my plunger knives as well as reshim the plunger. I got the baler back and he had set the knife clearance wrong causing the knives to hit. Put in a different set of knives but the baler is very noisy. When he replaced the track he did not replace the wear pads on the plunger. So the baler is going back to his shop and getting new pads and reshimming the plunger again. He told me he does not know why he did not put all new parts on the first time but he works on 5 NH balers to every one Deere. So it might be awhile before I get the baler working to be able to trouble shoot the thrower. Thanks you and the others that posted. Tom
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
