Posted by JK-NY on June 10, 2020 at 08:10:48 from (174.197.201.137):
Hello, 2 days ago while baling hay I developed an issue with my John Deere 5105 tractor I finished one small relatively flat field with no issues and went up the road and baled 2 more loads of hay also with no issues. I started on a third load and when baling the outside windrow (almost done) the tractor quit as I went uphill. I went yesterday and changed the fuel filter (100 hrs early by man. Interval) and it started right up but then quit again . After refilling the filter a couple times with similar results I took the fuel line off at the tank and filter and blew everything out and checked for flow out of the tank. It ran out a little slow from the tank( after giving my arm a good fuel bath) then ran good. After this and one more filling of fuel filter it started and ran good. I finished baling and raked some hay. When I started baling later that afternoon I had to go on flat ground 3/4 of the way then a gradual uphill and turn at the end steep uphill . On the steep uphill it quit again. The fuel tank is nearly full, I used a small air pump with a gauge to check for any possible sucking air by pressuring everything from the tank line up to the pump and everything was good. I plan to check the return line out . There is no transfer/lift pump and I don’t see where the injection pump has a lift pump built in like my bulldozer does . I am thinking of adding an 12v inline lift pump. Would that be a good idea? How much pressure would be necessary? Am I missing anything else here? I am going to try attaching pictures of the pump and it’s data tag. Sorry if this is a long post, I wanted to try and include as much information as possible.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
