Posted by RLP in Co. on June 07, 2020 at 14:30:33 from (174.254.196.168):
In Reply to: Plastic Welding posted by JimS on June 07, 2020 at 08:35:21:
This is what I used. I couldn't find the tip but it is only a piece of heavy wire bent with a flat tip a inch wide.I cut inch wide strips of 1/4" rabbit wire a then press the wire into the plastic with the hot tip. I tried a heat gun but it is too wild! You can easily melt a big hole fast! You need the big soldering iron to have enough heat. Press the rabbit wire deep into the plastic but not clear thru. After the strip is imbeded, melt some plastic of the same type over The top. On the finish side, I took a small pencil type soldering iron. and melted and smoothed the crack. I have a Kawasaki 400 Bayou that a buffalo had used for his play toy. It was VERY badly damaged! Cracks and broken off pieces everywhere! The fenders are all back together and maybe stronger than before. I still have one brace that I have to straighten and weld back on before I put the fenders back on. If a person had seen it before, you would not have believed it could be fixed!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
