Posted by louis n. on June 06, 2020 at 19:38:29 from (97.34.194.137):
My massey ferguson 12 baler gave me troubles on the left side knotter. It baled fine one day this week for 100 bales, and the next it baled about 10 and then started breaking the twine on the left side. It seemed the knot was staying on the bill hook and not releasing. I tried to spray the knotters with wd40 and see if they were just stuck, but it kept having problems, sometimes looking like the knot was not tying all the way with both ends. That may have just been from trying to get it back right once it was stationary and just tying small bales for trial sake. I"ve had this baler several years and its done well baling several hundred bales a year.
The twine cutters are sharp, bill hooks shiney and not worn or grooved, and the rollers on the hook both turn freely, no flat spots. The tension plate which the book roller rides on do have a penny deep or less groove worn in them. Could that cause a problem? Both left and right side tension plates are both worn the same, so I am thinking that is not the issue, but it could be contributing if the roller was full of dust and buildup keeping it from turning.
Please point me in the right direction to fixing this. Is it possible just the dust and grease could have fouled up the left side? I will try again this week on a busted bales to find out.
Also, if anyone has an old 3, 6, 9, 10 or 12 MF baler as parts, are a few parts I"d like to have spares of if you have them.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
