Posted by Hobo,NC on May 09, 2020 at 06:02:09 from (75.137.54.87):
In Reply to: Rear Main Side Seal. posted by showcrop on May 09, 2020 at 04:19:36:
Paper side seals coat with good RTV never depend on oil to seal them
Rubber with the pin YES a P.I.T.A. I still coat them with good RTV
Victor-Reinze RTV leave the bearing cap a little loose inject the RTV this leave a space between the cap and block for the air to be pushed out are probe/pack with a coat hanger.
Nissan seal sounds more like the paper I would treat the same with good RTV. Paper works good I don't depend on the oil to complete the seal...
On all check for leaks before you button the pan on I hope you have the engine on a stand leak check with low compressed air and a soap solution by applying air to the inside and soaping the outside.
All will BITE : ( I have had to keep at it mutable times to get a seal while the engine was on a stand. With the engine buttoned up block off all vents to the crank case apply low pressure air 1/2 to 2 lbs and soap the rear seal and all gaskets/seals this is the time to find the leak... This also works on the intake, fuel and cooling system...
If you can get your hands on one of these life will be good... I use a Red Line machine its saved my bacon and paid for its self several times over...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
