Posted by John T PS on April 29, 2020 at 05:52:55 from (45.16.200.171):
In Reply to: Re: Amps vs watts posted by Geo-TH,In on April 29, 2020 at 05:06:39:
Neighbor George, to your comment "So they can do all the math they learned in a class room, won't change a thing."
Actually math CAN ANSWER the "question asked" of how many watts are required to RUN a motor and actually math and engineering and physics CAN ANSWER the "question NOT asked" of what's required to START a motor, and I covered BOTH in my response. Having been an electrical engineer at the Century Electric Motor Company I can tell you from experience and education the math to RUN a motor may be less complicated then what it takes to START a motor. HOWEVER if you notice I told the poster the current required to START a motor may be 3 to 5 times what it takes to RUN a motor !!!!!!!!!!!!!
You're right, many lack the experience and/or education dealing with starting currents of a motor. I however do and try my best to explain it to the non electrical trained and experienced gents here.
You're also right, "the math wont change a thing" and that's true for the math to RUN a motor or the math to START a motor. Once calculated "it wont change" although physical wear and tear and friction and outside forces may change causing changes in the math.
Of course to each their own free choices, be it a Battery and Inverter orrrrrrrrrr a 12 VDC Compressor orrrrrrrrrrrr a Gas powered compressor. Each has advantages and disadvantages. Wouldn't it be a boring world if we all had to do things the same way or had to follow what one person chose.
Best wishes n God Bless neighbor, take care n stay safe
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
