It is very rare that the relief valve is out of adjustment, or that tightening it up will raise idle oil pressure.
Unless the spring is broken, the plunger is stuck, or something is holding the relief valve open, the problem is not in the relief valve.
Is this something new? As in a sudden loss of oil pressure? Is there any thing else unusual, like temperature increase, loss of power, unusual noises, extra blow-by?
If any of these are present, there is a problem that needs addressing.
But if it's been running near that pressure, or has very slowly dropped over the years, and everything else is still sounding and running the same, I would not be too concerned.
General rule of thumb, minimum allowable safe pressure is 10 PSI per 1000 RPM. That means if it has as low as 5 PSI at warm idle, it is moving oil through the system. I've seen old engines that would barely move the needle at idle, and they ran that way for ever.
Also consider it's use. This is not likely a working truck, and I hope it's not getting out on the freeway! So it probably has a fairly easy life.
Other things to consider, any chance the oil is contaminated with gas?
Has anything else been changed, like a hotter thermostat (if equipped)?
Does it have a canister type oil filter, and was it recently changed or added, or modified? The filter is likely a by-pass type that meters a small amount of oil through the filter and dumps back to the crankcase. If the orifice was enlarged or removed the oil pressure will drop.
The old engines were designed for straight weight, usually 30 weight oil. I personally prefer 15w40 diesel oil in the older engines, or stay with straight 30 or what ever the mfg recommended. It's rare low oil pressure can be corrected with heavier weight oil, but very light oil can lower it.
Hope there is nothing serious and it will be around for many more years!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
