Posted by steve terplak on April 05, 2020 at 05:18:54 from (174.197.200.49):
Sold my NH 488 to a guy who is picking it up tomorrow. I suggested he tow it home (25 miles?) but he isn't comfortable with that. He is bringing his large deckover trailer and his service crane truck (heavy equipment mechanic). He says lifting it to load will be no problem at all. I trust that he knows his equipment's capabilities.
From my end, I want to make this as easy and not timeconsuming as possible. So I have a few questions that other people may have already experienced...I have tried doing some online research but there isn't a ton of material. So if anyone has pics that would be great.
From what I have learned, it has to be loaded sideways and tongue/pto shaft removed. I saw mention of people loading it at an angle and just getting away with it but I'm thinking we should plan on the more traditional method. Also, have to put aNH 256 rake (no dolly) on too
I'm assuming we want to lock the head in transport position (up)? I'm thinking lift from 3 points with a chain/sling - each axle and the tongue?
Once on the trailer - block under the metal plate that the tongue sits in, block under the head, pull the single bolt that holds the tongue and pull it straight out? Is it that easy?
As for the PTO shaft...if memory is serving me correctly, it is a single section shaft....which means I need to pull the whole thing...does it just bolt into a splined shaft on the gear box? Or is it something more complicated...
Thanks in advance... I really wish he wanted to just tow it home...
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
