In 1964 I was on the school bus (the bus and driver, Klem, lived 2 miles away) in the seat behind Klem. We were in a snow drift about 14 inches deep and getting stuck. It was a 1948 Diamond T, and we were trying to back out of the drift, I heard a bit of added noise from the engine. As I watched the gauges, I noted a wiggle in the oil pressure that was in sync with the RPM. We struggled in the drift for about 5 minutes, going forward and back maybe 50 feet each time. The engine noise turned into a knock, and the needle on the gauge dropped to 20 PSI each revolution, from the 40 psi that was normal. I asked Klem if we were going to loose the engine. He said we already did, but he was going to keep it alive so we stayed warm. Andy (a school mate and friend of mine) had just been picked up about 300 yards prior, and he had a dad at home, and a Farmall M with plow, heat Houser, and chains. Klem asked andy to trudge back and ask for help. We were pulled backwards to Andy's house, where we stayed until a different bus came and took us all home. I do not care if the gauge wears out, I remember that indication of pressure variation to this day, and find that the engine is more valuable than the gauge. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.